Communicate with Supplier? Supplier
Nanhai Airbag Mr. Nanhai Airbag
What can I do for you?
Contact Supplier
 Tel:86-531-88723323
Home > News > Nanhai Airbag--Ship Launching Airbag
Online Service
Nanhai Airbag

Mr. Nanhai Airbag

Leave a message
Contact Now

Nanhai Airbag--Ship Launching Airbag

2019-07-09

Nanhai Airbag--Ship Launching Airbag

Ship Launching Airbags can be used for the ship launching or ship landing of tanker, tugboat or barges, carrying vessel, carrier, ferry and other special vessels (AHTS, DSV) and so on. The biggest vessel launched by ship launching airbags up to 85,000 DWT.

The air-bag application method for common medium ship launching is described as follows:

1. Based on calculation result, enough rolling air bags and lifting air-bags, towing machines and air compressors are prepared. Before using, an air bag shall be inflated and tested without load. In case of air leakage, the air bag must be repaired before using.

2. The roads for ship movement, including the road from the shipbuilding berth to ramp, must be cleaned up and flattened. Sundries must be removed from the roads, especially sharp iron nails andstone on the road, to avoid piercing the air bag. The ramp shall be enough long and wide in water3. All the protruding sharp corners and burrs on casting like"A" bracket and stern post and so on shall be ground flush/

4. Fasten the hull with the steel cable of traction winch.

5. Close all the sea chest valves on the ship, fix the rudder and propeller.

6. There are many ways to remove all blockes and fill in the rolling air bag.

7. Adjust pressure in the air bag so that the bottom can be lowered to appropriate working height. Make sure that the bottom will not touch the ground while moving the ship. For average small sized ship, the working height could be chosen Within the range of 0.2-0.3M.

8. All air bags shall be pointed at the center of the ship and perpendicular to the launching direction.

9. Start the traction winch to release steel cable slowing followed by slow movement of the ship. When the forefront air bag located in the front part separates from the bottom, it shall be put into the stern immediately and fill in the air bag according to the arrangmetn space of the air bag defined in the calculations.

10. Repeat the above process to move the ship to waterside slowly. When the air bag cannot be filled in, block the river and no ship is allowed to pass.

11. Evacuate personnel in the dangerous zone, inform staff on the ship to get ready. When conditions such as water depth and so on are gnough. Cut cable or unhook so that the ship can launch quickly. If the river is too narrow to realize quick launching, release the cable slowly by traction winch to launch the ship slowly.

12. For large ships, it`s necessary to install anti-skip device.

13. Collect air bags.

Ship Launching Airbag 14

Shandong Nanhai Airbag Engineering Co., Ltd.
Business Type:Manufacturer , Trade Company
Product Range:Air Dunnage Bag , Car Fenders
Products/Service:Yokohama Fenders , Ship Launching Airbags , Marine Salvage Pontoons , Pneumatic Fenders , Dock Fenders , Marine Airbags
Certificate:ISO9001 , OHSMS
Company Address:Donghao Industry Park, Mingshui Economic Development, Zhangqiu City, Shandong, Jinan, Shandong, China

Previous: Ship Launching Airbag Dia 1.2mx15m length,comply with ISO 14409

Next: Ship Launching Airbags

Related Products List

Home

Phone

Skype

Inquiry